 |
Vehicle Control Modules |
|
|
|
| Latching Relays |
| VCM-01 Alternating 12V |
| VCM-02 Alternating 24V |
|
|
|
|
|
| Time Delay Relays |
| VCM-03 On-Delay |
| VCM-04 Off-Delay |
| VCM-05 One-Shot |
|
|
|
|
 |
| Low Voltage Disconnects |
| VCM-06 (15 amp) |
| VCM-12 (20 amp) |
|
|
|
|
|
|
|
| Solid State Relays |
| VCM-10 Dual input |
|
|
|
|
- For 12 volt loads that need to run a certain time before disconnection
|
- Standard automotive pin relay format
- Shut-off timer of 0 to 60 minutes adjustable, 60 minutes fixed, or 5 minutes fixed
- Durable metal case
|
VCM06's contain a microprocessor controller and a solid state 15 amp power switch for powering 12 volt output loads. Over current and short circuit fault shut down protection are included. The voltage level of the 12 volt power input is continuously monitored and will turn on automatically to supply the required power. If the voltage on the input drops below 12.8 volts, a time delay is started. The unit will disconnect power to the loads based upon the shut-off timer settings. Shut-off timer options include adjustable and fixed time units.
Models include:
| VCM-06 |
0 to 2 hours adjustable |
| VCM-06-60MF |
60 minutes fixed |
| VCM-06-05MF |
5 minutes fixed |
|
- 4-wire terminal configuration
- Shut-off timer of 5 or 60 minutes
- Durable metal case
|
The VCM-12 4-wire terminal configuration allows easy installation in two conductor power cables typically used with 12 volt power point supplies. It contains a microprocessor controller and a solid state 20 amp power switch for powering the output loads. It has over current fault shut down protection.
The VCM-12 continuously monitors the voltage level of the 12 volt power input. When the voltage is above 13.25 volts the power switch will turn on to supply up to 20 amps on the output terminal to power the loads. If the voltage drops below 12.8 volts, a timer is started. If the voltage remains below 12.8 volts until the timer expires, the power switch will turn off, disconnecting the power to the loads. If the voltage drops below 11.8 volts with the timer running, the power switch is shut off immediately. Any time the input voltage increases to above 13.25 volts the power switch will turn on to supply power to the loads and the timer will be reset.
Models include:
| VCM-12-1-60M |
60 minutes fixed |
| VCM-12-1-05M |
5 minutes fixed |
|
|
|
|
