 |
Vehicle Control Systems |
|
|
|
|
|
| Customized Configurations |
|
|
|
|
|
| Analog/Battery Monitoring Configurations |
|
|
|
|
|
|
The Standard Configuration VCMS (VCMS-SC) consists of a six-position Switch Module (SM) and a remote six output Power Module (PM). Each push button position contains a status LED that indicates if the switch is on or off. Switch legends are customized for your needs. The system's power module is remotely located from the switch module and connected with a communications logic cable. This cable is available in standard lengths. The power module contains six 12 volt 15 amp outputs for powering the auxiliary loads. The switch module positions activate their respective power module outputs (SW1=Output 1, SW2=2, etc.). Each switch position can be set up to operate as a two-position latching (push to turn on, push again to turn off) function or as a momentary (turned on only when button is pressed) switch.
|
|
|
|
